While recently discussing dovetails with some friends I asked how many dovetails could they name. Most admitted four or five. When I obtained my AAS degree in Fine Woodworking I had to list nine. So I began to research the … Continue reading
Jerill Vance
One of the reasons I enjoy woodworking is because there are so many different ways to complete the same task. In most cases there is no “right” or “wrong” way but instead a method that is most suited to your … Continue reading
There is considerable interest in “green woodworking” in this day and time. Most think this means using green or wet wood or woodworking without the use of utilities. Some think of it as a way of utilizing the resources available … Continue reading
As most of you know, there is a wave of winter invading the northeast producing snow and extreme cold weather. Since the weather prohibits most outdoor activities (except those related to the snow) it is a good time to make … Continue reading
Like most woodworkers, I get requests to build something in a hurry and without spending a lot of money on supplies. Most of the time I schedule the work but this request was from someone special. The client, my … Continue reading
Woodworkers not only need tools but also value them for the use they serve. Most craftsman drool over new tools that make specific tasks easier to perform. Some look through flea markets and yard sales for a good deal … Continue reading
I recently built a Moxon vise to make it easier for me to cut dovetails at the “work station” instead of my work bench. I have better light at the work station, therefore, it is much easier to see to mark and … Continue reading
To minimize wood movement, the moisture content needs to be a known factor. Most woodworkers use a moisture meter to measure the amount of water left in the wood after the drying process but this is not always accurate, no … Continue reading
Wood is hygroscopic – it gives off water and takes on water as the environment changes. So, wood is continually shrinking and expanding as it acclimates to the environment. Freshly cut or “dead green” wood can have over 100% moisture … Continue reading
In woodworking most tools need to be sharp to do quality work. We spend a great deal of pride and time in getting them sharp and maintaining the edge. Many woodworkers have asked me when is a cutting edge sharp. … Continue reading